3D Printer Controller Board For RAMPS 1.4 / REPRAP MENDEL PRUSA dgo

3D Printer Controller For Arduino Boards RAMPS 1.4 Reprap Mendel Prusa Support W

Introduction:

This board is mostly based on Adrian’s Pololu_Electronics and work by Tonok.
Copper etch resists methods suggested by Vik. Also inspired by Vik’s work with EasyDrivers. circuit design based mostly on Adrian’s Pololu_Electronics Joaz at supplied initial pin definitions and many design improvements.
Much inspiration, suggestions, and ideas from Prusajr, Kliment, Maxbots, Rick, and many others in the RepRap community

Features:

•Extended to the control parts.
•The heater / fan output and 3 thermistor circuit MOSFET
•fusion 5A extra security and component protection
•The option 2 motors are connected to the Z Prusa Mendel
•LED indicates the heater output
•The SD card add – is now available from Kliment – Sdramps
•The I2C and SPI pins left for future expansion.

Package included:

•1 x 3D Printer Controller board for RAMPS 1.4

Product Features

  • LED indicates the heater output
  • The option 2 motors are connected to the Z Prusa Mendel
  • fusion 5A extra security and component protection
  • The heater / fan output and 3 thermistor circuit MOSFET
  • Extended to the control parts.

Visit The Website For More Information…

Published by

Best 3D Printer Specialist

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.