3D Printing Filament PLA 3mm 1KG spool (black), Dimentional Accuracy +/- 0.03mm

ArrayBay 3D printing filament means quality that is perfect for a variety of 3D printing project. This filament uses PLA (Polylactic Acid), 1kg spool with a 3.0mm diameter with an accuracy of +/-0.03mm. The processing temperature of this PLA is 190° – 230° C.

Quality is important for 3D printing, our filaments have very low water absorption, no air bubbles occur when printing. PLA is one of the most common materials used for 3D printing because of it’s accuracy, strength and has minimal warping or shrinking of your prints. It is a material that is a great choice for printing that requires flat areas or more accurate angles.

Product Features

  • 3mm Filament Diameter PLA material
  • Recommended processing temperature: 190° – 230° C
  • Filament roundness: +/-0.03mm

Check Out Our Website For Details…

Published by

Best 3D Printer Specialist

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

3 thoughts on “3D Printing Filament PLA 3mm 1KG spool (black), Dimentional Accuracy +/- 0.03mm”

  1. Unless my roll was bad, I would avoid this brand thankfully when I bought this item it was only $14 prime shippedit had to be run at much higher temps then normal, almost similar to petg for some reasonthen near the end of the spool because I used around 98% of it before writing this review it started to get a weird glaze look to the finishmaybe then the temps were too hot, but for the majority of the spool it would not work at the usual 205-210 temps I normally run pla atso who knows, but I…

Comments are closed.