Wangdd22 3D Printer J-head Hotend with Fan for 1.75mm 12v V6 Direct Filament Wade Extruder 0.4mm Nozzle+Volcano kit

Descriptions:

●With PTFE in hot regions of our HotEnd we can reach 260C with the supplied thermistor. By swapping a thermistor for a thermocouple (may require additional electronics) you can reach over 280C.
●This not only allows you to print extremely high temperature materials like PP/ Polycarbonate and Nylons but also eliminates HotEnd meltdown failures associated . latest v6 hotend has a PTFE liner inside the hotend this liner is never subjected to high temperatures so there is no risk of damaging the liner through overheating.
●Our new HeaterBlock gives the fastest heat up times and the most responsive temperature control by clamping around the cartridge for maximum thermal contact. The new thermistor placement means you get the most accurate temperature readings with the fastest response. What this means for you the user is that you can go from 20C to 200C in just 65 seconds, temperature control is responsive enough that you can keep the hotend within 0.5C of your set temperature or less with ease.

Reduced Bulk and Z-Height.

About Volcano kit:
●1 pcs Volcano Heating block.
●4 pcs long nozzles(1.75mm/0.6mm,0.8mm ,1mm,1.2mm)

●We’ve focused on cutting as much bulk from the V6 as possible. This means an overall length of just 72mm and significant reductions in bulk in the X/Y dimensions by using our new injection moulded fan duct.

Package Included:
●1 x Metal J-Head hotend 1.75mm / 0.4mm nozzle / 12V 40W Heater / NTC3950 Thermistor
●1 x Heatsink shroud with 12V 0.13A High Speed Fan 3010S
●1 x One meter long bowden PTFE/teflon tubing 4mm OD 2mm ID
●1 x Pneumatic Straight Fitting to connect to extruder cold end
●1 x Volcano Heating block
●4 x long nozzles

Product Features

  • The bowden tube can be removed to be used for a direct drive extruder
  • RepRap 3D printer extruder hotend compatible with E3D V6 1.75mm / 0.4mm
  • Metal construction with PTFE liner inside, good for ABS, PLA and other conventional print materials
  • 12V 40W heater, 12V high speed fan with shroud, NTC 3950 pre-wired thermistor
  • Easy No-Solder, No-Tape, No-Adhesive assembly and maintenance.

Click Here If You Need More Detailed Info…

Published by

Best 3D Printer Specialist

3D Printing. The next Goldrush is on it´s way. Inside information on how to start printing in 3D, where to buy Printers, how to use them, and the newest Pictures and reviews of available 3D Printers.

2 thoughts on “Wangdd22 3D Printer J-head Hotend with Fan for 1.75mm 12v V6 Direct Filament Wade Extruder 0.4mm Nozzle+Volcano kit”

  1. … to install it but at first glance it looks good. I took it completely apart to inspect it … Haven’t had a chance to install it but at first glance it looks good. I took it completely apart to inspect it and was impressed with the fit and finish. All the threads and surfaces are clean and without any burs. The throat and cold end seem clean and polished enough to hopefully not cause any problems. I might never use the volcano kit but but then again I might.I’ll make sure to post if I run into any issues or corrective actions but I’m guessing that won’t be necessary. Might…

Comments are closed.